I recently upgraded some disks in my TS-412 NAS and it was taking some time. I vaguely recalled playing with min and max settings on the TS-639. Here’s a link to the QNAP forums on how to do it. The key is the min setting, and, as explained in the article, it really depends on how much you want to clobber the CPU. Keep in mind, also, that you can only do so much with a 3+1 RAID 5 configuration. I had my max set to 200000, and the min was set to 1000. As a result I was getting about 20MBs, and each disk was taking a little less than 24 hours to rebuild. I bumped up the min setting to 50000, and it’s now rebuilding at about 40MBs. The CPU is hanging at around 100%, but the NAS isn’t used that frequently.
To check your settings, use the following commands:
cat /proc/sys/dev/raid/speed_limit_max cat /proc/sys/dev/raid/speed_limit_min
To increase the min setting, issue the following command:
echo 50000 >/proc/sys/dev/raid/speed_limit_min
And you’ll notice that, depending on the combination of disks, CPU and RAID configuration, your rebuild will go a wee bit faster than before.